Door does not bear the weight of the tank body, tank does not deform due to the weight of the tank door.
Close the door and considerate tank after tank without rotation, by the third ring clamping. Tank door switch back and forth.
Tricyclic structure activity between the door and the door ------ Fixed door is not rotating, tightly sealed by the third ring card, seal the door when the switch is not affected by friction and wear.
No tooth structure ----- knocker door switch is not on the (unlike toothed ring structure requirements for the door, and elliptical deformation due to the tank, causing alveolar activities falling door stuck, switch interference door seals).
Tank door seals rely on hot compressed gas tank seals , seals without external compression .
As the tank door lock without rotation , seals will not be friction and wear .
Te Luzi seal material used is currently the world's best gasket material that can withstand high temperatures of 200 ° C .
To ensure the seal from heat damage,特鲁兹working temperature reaches 200 ° C above the autoclave is equipped with a seal cooling system , so that at high temperature gaskets have a longer life expectancy.
Heating the multilayer tubes finned heater is disposed in the inlet end of the centrifugal fan
So between the heater full cycle gas heat exchange , have a good effect of heat exchange , thermal energy utilization.
When pre-cooling , air cooling water atomization. Under the action of the compressed gas , as gas atomized water as evenly into the autoclave each pipe cooler , cooler ministries so consistent cooling rate , the cooler water to drain small subjected to thermal shock , thermal deformation and cooling rate can be controlled accurately in the autoclave .
Surface design for wind turbine blades and pumping duct , duct design
High temperature uniformity up to ± 1 ℃
